«

»

Nov 30

How to Carry Out a Thorough Car Seatbelt Inspection

There is no doubt that seatbelts are among the primary car safety features. They are made to be strong, effective and durable. However, they are subject to constant wear and tear due to extensive use and sun exposure. That is why they have to be inspected on a regular basis and replaced if needed. Find out how to inspect them properly.

Webbing

The webbing is the fabric material which goes over your lap and chest when you travel. It is the seatbelt component which is most prone to damage. You need to pull out the entire belt and inspect it carefully for cuts. You should know that even a tiny cut can reduce the strength of the webbing by as much as two thirds. Look closely at the edges of the webbing to spot fraying. Watch out for unusual wear. Pay attention to the thickness, weave and strength of the material.

There are some areas which are particularly prone to wear and tear and fraying. You need to pay special attention to them. You have to inspect the area next to the latch, the area which goes over the shoulder of the passenger when the seatbelt is worn and all areas which are in contact with the seat.

Buckle and Latch

You have to inspect the seatbelt buckle carefully as well. Look at it from all sides and watch out for cracks, chips and other kinds of damage. Sometimes, it is not obvious that the buckle is broken. That is why you have to test it. Insert the latch into the buckle. If you hear a click, then the feature is working properly.

The latch requires careful inspection as well. Watch out for signs of wear and tear and rust and corrosion. Look carefully for deformations. Tug on the safety belt to ensure that the latch is properly attached. Insert the latch into the buckle slowly. It must slip in smoothly. Again, an audible click is a sign that all is fine.

Retraction Operation

The retractor is a major component of the system as it enables the seatbelt to fit snugly and to stay in place during a crash. You should run a simple test to ensure that it is working fine. Pull the belt and release it slowly. It must spool out and retract without binding.

If the inspection reveals any signs of damage or faulty operation of the seatbelts, they must be replaced immediately with new ones. This will guarantee the safety of everyone in the car.

Facebooktwittergoogle_plusredditpinterestlinkedinmail

Leave a Reply